ACLG-001 Lens Guard for Aimpoint® COA®

The Aimpoint®  COA is taking center stage in the red dot optic world for its next generation -
pistol mount interface and operator-friendly features. COA has emerged as the ‘go-to’ red dot
optic for professional working pistols. The rugged closed-emitter design and aerospace grade
aluminum case has proven to take a beating that sidelines competitors.

 

Field duty is unforgiving, however, and one hard impact to the front lens could sideline the optic.

The good news is it is easily replaced at minimal charge.

The bad news, it has to go back to the factory for that service.

 

Avoid the hassle and protect your expensive red dot with our ACLG-001 Lens Guard.
Precision CNC machined aerospace grade aluminum frame, with Type III hard coat anodize,
easily attaches in seconds to your COA with provided stainless-steel set screws and wrench.

The Lens Guard also makes a ‘slide racker’, without leaving hand prints on your COA front lens, if needed.

 

Note: The ACLG- series Lens Guards mount to the front of the optic only. Order contains one Lens Guard only.

 

Features:

• Easily attaches with supplied stainless-steel fasteners and wrench

• Type III Hard Coat Anodize

• 6061 T6 CNC machined frame provides maximum COA front lens protection

Colors available: Black Only

Important Note: COA Lens Guard fasteners are 3-48 in size. This means VERY SMALL! 

We recommend just finger tight only on these screws. In extreme applications, use only the weakest available grade of thread locker, such as Loctite 222 purple.

Wrench: .050 Hex