AALG-001 Lens Guard for Aimpoint® ACRO® P2

(No reviews yet) Write a Review
Adding to cart… The item has been added

The Aimpoint®  ACRO®  P2 is rapidly becoming the ‘go-to’ red dot optic for professional working pistols. The rugged closed-emitter design and aerospace grade aluminum case has proven to take a beating that sidelines competitors. That said, the front lens is front and center for taking potential damaging impact. The good news is, it is easily replaced at minimal charge. The bad news, it has to go back to the factory for that service. Avoid the hassle and protect your expensive red dot with our P2 Lens Guard.

Precision CNC machined aerospace grade aluminum frame, with Type III hard coat anodize, easily attaches in seconds to your P2 with provided stainless-steel set screws and wrench. The Lens Guard also makes a great ‘slide racker’, without leaving hand prints on your P2 front lens.

The AAL-01 P2 Lens Guard works best on OEM ‘Optic Ready’ (OR) systems utilizing mount plates. For direct cut slides (DCS), see our AALG-02 Model found HERE

Note: The P2 Lens Guard does NOT fit the ACRO®  P1.

Note: The AALG- series Lens Guards mount to the front of the optic only. Order contains one Lens Guard only.


• Easily attaches with supplied stainless- steel fasteners and wrench

• Type III Hard Coat Anodize

• 6061 T6 CNC machined frame provides maximum P2 front lens protection

Colors available: Black Only

Important Note: P2 Lens Guard fasteners are 2-56 in size. This means VERY SMALL! We recommend just finger tight only on these screws. In extreme applications, use only the weakest available grade of thread locker, such as Loctite 222 purple.


Lose a Fastener? Spare lens guard fasteners are available here: Replacement Fasteners


TangoDown does NOT ship outside the United States

Related Products